TM 9-2350-222-10-3
MAINTAIN TRACK (CONNECT TRACK) - Continued
NOTE
If outer pins (G) are too far apart to at-
tach track fixtures, wedge crowbar (A)
between two end connectors and pull
back to wrap track around compen-
sating idler wheel (H). Hold until track
fixtures can be connected.
2. Lineup outer pins (G).
3. Other two crewmembers attach track fixture (B) or (D) to outer track pins
(G). Using ratchet or bar, turn counterclockwise and tighten.
4.
Remove crowbar (A).
5. Line up inner pins (J).
6.
Attach second track fixture to inner pins (J).
7.
Tighten both track fixtures (B) or (D) evenly by turning counterclockwise
until links (K) are almost touching.
NOTE
Use new centerguide bolt and nut if available.
If not, replace as soon as possible.
8. Install both outer and inner connectors (page 3-76).
TA132910
3-80
