ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts
Tools
Rags, Wiping (Item 7, Appendix D)
General Mechanic's Tool Kit (Item 1, Appendix B)
Wrench, Torque (NSN 5120-00-853-4538)
Solvent, Drycleaning (Item 8, Appendix D)
(Item 6, Appendix B)
Gasket, Oil Pan Mounting (NSN 5330-00-073-3042).
Equipment Condition
Oil pan cover and shroud removed (para. 4-22).
(1) Remove either drain plug (1) or (2) and drain oil into suitable container.
(2) Remove ten assembled screws and washers (3) and remove oil pan (4), gasket (5) and O-ring (6) and
special studs (7).
WARNING
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100F.-138F. (38C.-60C.).
(3) Clean oil pan (4) with drycleaning solvent and dry thoroughly.
(4) Inspect oil pan (4) and replace if cracked or otherwise damaged.
(5) Remove and inspect drain plugs (1) and (2) and gaskets (8) and replace as needed.
(6) Inspect O-ring (6) and replace if ripped or otherwise damaged.
(7) Inspect special studs (7) and replace if damaged.
(1) Ensure gasket mating surfaces are clean and old gasket material is removed.
(2) Install oil pan (4), O-ring (6), and gasket (5) and secure with ten assembled screws and washers (3)
Torque screws to 25-30 in.-lb (4465-5358 gr cm).
(3) Install drain plugs (1) and (2) and gaskets (8).
