ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
6-9. Camshaft, Camshaft Gear, and Bearing.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Condition
Tools
Oil pump gears removed (para. 5-9).
Materials/Parts
NOTE
Remove camshaft gear, key, camshaft, bearing and spacer as an assembly.
(2) Remove two assembled screws and washers (1), and remove camshaft gear (2), key (3), camshaft (4),
spacer (5) and bearing (6).
WARNING
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100F.-138F.(38C.-60C.).
(3) Clean all items with drycleaning solvent and dry thoroughly.
(4) Inspect all items and replace worn or otherwise damaged parts. Refer to Table 6-2 for wear limits.
b. Installation. (figure 6-5)
(1) Install bearing (6), spacer (5), key (3) and camshaft gear (2) onto camshaft (4).
(2) Install camshaft (4) with all items installed, and aline timing marks on camshaft gear (2) with timing
mark on crankshaft gear (7).
(3) Install two assembled screws and washers (1).