TM 9-3405-206-14 & P
28-463 1115 VOLT) and 28-464 (230 VOLT)
BAND SAW BLADE BUTT WELDERS
Fig. 1.
INSTALLATION
1. Mount the welder on the Cat. No. 28-462 blade welder bracket and
attach the bracket to the side of the band saw. The welder can also be
mounted on any flat surface. The two mounting brackets supplied on the
base of the welder have been tapped to provide four mounting holes.
2. The 28-463 welder draws 14 amperes and should be connected to a
115 volt single phase, 50 or 60 cycle supply. The 28-464 welder draws 7
amperes and should be connected to a 230 volt, single phase, 50 or 60
cycle supply. DO NOT USE AN EXTENSION CORD. FULL LINE
VOLTAGE IS REQUIRED FOR GOOD WELDS.
3. The 28-464 welder is supplied with a single receptacle, which mates
with the 230 volt tandem blade plug on the cord supplied with the welder.
This receptacle can be mounted interchangeably with single 115 volt
receptacles, e.g. the 115 volt receptacles supplied with 20" metal cutting
band saws. 230 volt single phase power and a ground wire must be
brought to this receptacle.
29