NEW
FORM G2
NEW FORM
1. NEW START WINDING CUT-OFFS provide quiet,
8. NEW RAISED END-SHIELD BOSSES and machined
dependable operation. Motors have either built-in relay
OD are held to close tolerances for accurate mounting of
or compact centrifugal mechanism and switch.
customer's adapter.
Throughbolt nuts are easily
2. NEW QUIET ALL-ANGLE SLEEVE BEARING HAS
accessible.
GREATER load carrying ability. Double feeder wicks
9. NEW HEAVY RIBBED STEEL BASE gives motor
supply new %-inch diameter shaft-bearing surfaces
Either resilient or solid cradle base
assuring long bearing life.
mounting available.
3. NEW PRE-TEMPERED SPRING-STEEL THRUST
10.
NEW TERMINAL BOX LOCATION is easily
accessible and slotted conduit box cover slides off easily
PLATE and molded end thrust washer with positive
by simply loosening two screws. Easy-to-read cover has
lubrication have extremely low coefficient of friction.
indicator for rotation change and lubrication instructions.
They permit 23 lbs end thrust for heavier loads, and
11. NEW TERMINAL BOARD is provided with both
lengthen motor life.
conventional studs and quick connects for easy hookup.
4. NEW WINDING GUARDS give Form G2 motor extra
12. NEW CONDUIT CONNECTION-Formed shell has
dripproof protection, shield windings from dirt and water.
extra strong thread. Knock-out plug in located 300
5. NEW VENTILATION SYSTEM provides balanced
above centerline for easy access.
cooling at both ends of motor for long life. All air enters
13. NEW GUIDE-CHUTE channel leads in straight line
through end shields, exhausts through shell.
to terminals, simplifying line connection.
6. NEW INTEGRAL INSULATION has outstanding
14. NEW PROTECTED GROUNDING STRIP in resilient
method of application are U.L. recognized.
base motors provides greater safety. 2 1/2-inch cushion
ring
minimizes
vibration.
7. NEW FLAT END SHIELDS have heavy ribbing for
extra rigidity. Die-cast aluminum construction resists
corrosion.
G-2 MOTOR FOR MODEL CHY-B--BENCH HONES
45