TM 9-4110-255-14
(3) Nozzle to injection pump hose.
(a) If union (13) was removed, install new washer (16), eye (15), new washer (14), and union.
(b) If eye (9) was removed, install new washer (12), eye, new washer (11), and union (10).
(c) Slide two new clamps (7) over hose (8) ends and install hose. Secure clamps.
(d) Install new gasket (6), cover (5), and three screws (4).
(e) Install cylinder casing (3), flat washer (2) and screw (1).
NOTE
FOLLOW-ON MAINTENANCE:
Connect battery (para 4-35) and put unit back into service.
4-64. IN-LINE FUEL FILTER REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts:
Equipment Conditions:
Wiping Rags
Refrigeration unit shut down (para 2-7) and battery
Right side door open.
WARNING
Hoses may contain fuel. Injury to personnel can occur when removing. Appropriate actions
should be taken to contain spills.
NOTE
Note fuel flow direction before removal.
a. Removal. Loosen two clamps (1) then remove in-line fuel filter (2) and clamps.
4-153