TM 9-4110-255-14
(3) Fuel pump to fuel filter hose assembly.
(a) If eye (22) was removed, install new washe (25), eye, new washer (24), and union (23).
r
(b) If eye (26) was removed, install new washer (29), eye, new washer (28), and union (27).
(c) Slide one each clamp (20) over hose (21) ends and install hose. Tighten clamp.
(d) Install loom (19) over hose (21) and secure using tie down straps (18) as necessary.
(4) In-line fuel filter to fuel pump hose assembly.
(a) If eye (14) was removed, install new washer (17), eye, new washer (16) and union (15).
(b) Be sure to observe in-line filter (3) flow direction noted during removal then slide one each clamp
(12) over hose (13) ends and install hose. Tighten clamps.
(c) Install loom (11) over hose (13) and secure using tie down straps (10) as necessary.
(5) Fuel tank to in-line fuel filter hose assembly.
(a) If removed, install fuel inlet elbow (7).
(b) If removed, install new nut (8) and new tube ferrule (9) onto new connector (6). Install connector into
fuel inlet elbow (7) and tighten nut to compress tube ferrule.
(c) Be sure to observe in-line filter (3) flow direction noted during removal then slide one each clamp (4)
over hose (5) ends and install hose. Tighten clamps.
(d) Install loom (2) over hose (5) and secure using tie down straps (1) as necessary.
NOTE
FOLLOW-ON MAINTENANCE:
Close both side doors.
Connect battery (para 4-35) and put unit back into service.
4-149
