TM 9-4110-255-14
5-17. DEHYDRATOR REPLACEMENT . - Continued
b. Installation.
NOTE
Do not remove dehydrator protective caps until just before installation. This will minimize the
risk of contaminating the dehydrator. Be sure to observe flow direction noted during removal.
(1) Install new dehydrator (5), clamp (4), clamp (6), flat washer (3), and bolt (2).
(2) Tighten two flare nuts (1).
NOTE
FOLLOW-ON MAINTENANCE:
Leak check (para 5-13), evacuate (para 5-14), and charge (para 5-15) the refrigeration system.
Close left side door.
5-18. COMPOUND GAGE REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts:
Equipment Conditions:
Self Locking Nuts (3)
Refrigeration system discharged (para 5-10).
6, Appendix G
Left side door open.
Anti-Seize Tape
27, Appendix E
Silicone RTV
1, Appendix E
a. Removal.
(1) Loosen flare nut (1) and move copper tubing (2) over to one side being careful not to bend or kink tubing.
(2) Remove coupling (3).
(3) Remove three self locking nuts (4), bolts (5) and compound gage (6). Discard self locking nuts.
5-34
