TM 9-4110-255-14
5-30. SOLENOID VALVE L1 (LIQUID LINE) REPLACEMENT .
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions:
Materials/Parts:
Marker tags (2)
Refrigeration system discharged (para 5-10).
4, Appendix E
Left side door open.
Lock Washers (2)
Accumulator removed (para 5-29).
32, Appendix G
a. Removal.
(1) Tag and disconnect wire leads (1).
NOTE
Solenoid coil mounting hardware is supplied with solenoid valve.
(2) Remove screw (2), lock washer (3), data plate (4), and solenoid valve coil (5).
NOTE
Note flow direction prior to removal.
(3) Loosen two flare nuts (6) then remove two bolts (7), lock washers (8), and solenoid valve (9). Discard lock
washers.
b. Installation.
NOTE
Be sure to observe flow direction noted during removal.
(1) Install solenoid valve (9), two new lock washers (8), and bolts (7). Tighten two flare nuts (6).
(2) Install solenoid valve coil (5), data plate (4), lock washer (3), and screw (2).
(3) Using tags and wiring diagram (fig. 2-4), connect wire leads (1). Remove tags.
5-53
