TM 9-4110-256-14
4-5. SERVICE UPON RECEIPT OF MATERIAL.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage on SF 364, Report of Discrepancy.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
4-6. INSTALLATION INSTRUCTIONS.
a. Tools and Equipment. Tools required to install the refrigeration unit include a wrench for tightening the mounting
angles, lifting sling(s), spreader-bar (if needed), and hoist or similar lifting device.
b. Refrigerator Enclosure Preparation. The refrigerator enclosure must have an opening 38.00/38.06 inches
(96.52/96.67 cm) wide and 55.00/55.06 inches (139.70/139.85 cm) high (fig. 4-1) to insert the refrigeration unit.
If an opening does not already exist in the enclosure, see the enclosure manual for information on making such
an opening.
Figure 4-1. Wall Opening Dimensions
c. Installation.
(1) Remove four nuts (1, fig. 4-2), lock washers (2), and unit mounting angles (3) if attached to the
refrigeration unit. If the mounting hardware is not attached, locate it now.
4-2
