TM9-4120-370-14
TO35E9-229-1
4-38. WIRING HARNESS AND ELECTRICAL LEAD, CONTROL PANEL - Continued.
(3) Tag and disconnect leads from switches.
(4) Remove harness and lead.
d. Repair
[1) See paragraph 4-36 for general wire repair instructions.
(2) See Table 4-2 (Wire List) for wire lengths and terminal information when individual wires are replaced.
Installation
e.
(1) See tags and wiring diagram (Figure 4-20) and reconnect leads.
(2) Using screwdriver and wrench, secure ground wire to ground stud with flat washer, lock washer, and lock
nut.
(3) Remove tags.
(4) Using screwdriver and wrench, secure connector J8 to box with four screws and nuts.
(5) Insert rear panel into box and aline holes.
(6) Using screwdriver and wrench, secure rear panel with four screws and nuts.
(7) Place Temperature control thermostat knob on shaft and aline setscrew with flat on shaft.
(8) Using allen wrench, tighten setscrew.
Follow-on procedure: install control panel. (See para 4-37.)
Preliminary procedure: Remove control panel. (See para 4-37.)
