TM 9-4120-378-14
4.8 CONNECT THE POWER SOURCE.
Make sure the Mode Selector switch is in the OFF position.
For safe operation, connect aground wire (at least No. 10 AWG) to the ground con-
nection.
a. Connect the air conditioner power cable to a 115 volt, 50/60 Hz, single-phase power source.
b. If auxiliary power input connector (J 11) is used, refer to Appendix F, Wiring Diagram, for connections.
4.9 OPERATION CHECK AND ADJUSTMENTS.
a. Check operation of unit.
b. Check for proper fan rotation. With the fan rotating, check to see that air is sucked through evaporator inlet louver
and blown out through evaporator outlet louver.
