TM 9-4120-385-14
4-19. CONNECTOR COVER Continued
WARNING
High voltage can kill.
1. Unscrew cover (2) from connector (4).
2. Remove one screw (1) to release cover (2).
3. Remove remaining three screws (1) to release gasket (3) and connector (4).
4.
Reach inside casing to remove connector (4) and gasket (3).
b. INSPECTION.
1.
Check cover for cracks and thread damage.
Replace cover if defective.
3.
4. Replace connector if damaged.
INSTALLATION.
c.
1.
Reattach connector (4) and gasket (3) with three screws (1).
2.
Screw cover (2) onto connector (4) and hand tighten.
3. Install cover chain to back plate with one screw (1).
This task covers:
c. Test
d. Repair
a. Removal
b. Inspection
e. Installation
INITIAL SETUP
Equipment Condition
Test Equipment