TM 9-4120-401-14
ELECTRICAL ACCESS PANEL.
This task covers:
a. Remove
b. Clean
c. Install
INITIAL SETUP
Tools
Equipment Conditions:
Refrigeration Unit Service Tool Kit
Scrub Brush
Use disconnect switch (NOT POWER
CABLE) to disconnect power to unit.
Damage to cable connector pins will
Materials/Parts
result if cable is used.
Lock washers (13)
Disconnect power at power source,
Lock washers (4)
Disconnect power cable from unit.
Lock washers (2)
Lock washers (4)
Rags
Dry Cleaning Solvent
Detergent
a. Removal.
(1) Loosen captive mounting screw (1) and carefully work control panel (2) from unit.
(2) Remove 13 sets of screws (3) and lock washers (4) and four sets of screws (5), lock washers (6), and flat
washers (7).
(3) Carefully pull access panel (8) from unit as far as wiring harnesses will allow.
(4) Remove two sets of screws (9), nuts (10), flat washers (11), and lock washers (12) holding connector
(13) to access panel (8).
(5) Remove four sets of screws (14), nuts (15), and lock washers (16) holding connector (17) and rubber
gasket (18) to access panel (8).
4-35