TM 9-4120-401-14
4-12.
ELECTRICAL ACCESS PANEL. - continued
NOTE
FOLLOW-ON MAINTENANCE:
Connect power cable to unit.
Connect power at power source.
CIRCUIT BREAKER AND PRESSURE SWITCH COVER (EMP EQUIPPED UNITS ONLY).
c. Install
b. Clean
This task covers:
a. Remove
INITIAL SETUP
Materials/Parts
Tools
Lock Washers (6)
Refrigeration Unit Service Tool Kit
Appendix B, item 1
Rags
Appendix E, item 13
Scrub Brush
Appendix B, item 2
Dry Cleaning Solvent
Appendix E, item 3
Detergent
Appendix E, item 15
a. Remove.
Remove six sets of screws (1), lock washers (2), and flat washers (3). Remove cover (4).
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Do not use near open flame or excessive heat. Use in well
ventilated area.
b. Clean.
Clean the cover with a rag dampened with a detergent solution or dry cleaning solvent. Use a soft brush if
necessary to dislodge caked on dirt. Dry the item thoroughly.
4-37
