TM 9-4120-401-14
VENTILATION COVER (EMP EQUIPPED UNITS ONLY).
c. Install
b. Clean
a. Remove
This task covers:
INITIAL SETUP
Materials/Parts
Tools
Lock Washers (4)
Refrigeration Unit Service Tool Kit
Appendix B, item 1
Rags
Appendix E, item 13
Scrub Brush
Appendix B, item 2
Dry Cleaning Solvent
Appendix E, item 3
Detergent
Appendix E, item 15
a. Remove.
Remove four sets of screws (1), lock washers (2), flat washers (3), and two snap fastener studs (4). Remove
cover (5).
Dry cleaning solvent used to clean parts is potentially dangerous to personnel
and property. Do not use near open flame or excessive heat. Use in well
ventilated area.
b. Clean.
Clean the cover with a rag dampened with a detergent solution or dry cleaning solvent. Use a soft brush if
necessary to dislodge caked on dirt. Dry the item thoroughly.
c. Install.
Position cover (5) onto unit and align the mounting holes. Secure with four sets of screws (1), lock washers
(2), flat washers (3), and two snap fastener studs (4).
