TM 9-4120-402-14
4-5.
INSTALLATION INSTRUCTIONS. - continued
7
Install connector J4 in alternate location using hardware and gasket removed in step 4
above.
8
9
10
(2)
If it is desirable to mount the control module in a remote (mounted elsewhere in the conditioned space)
location, the following steps must be taken.
(a)
Loosen captive mounting screw and pulling screw, remove control panel.
Figure 4-5. Control Panel Removal
(b)
(c)
Secure control panel at new location and connect remote control cable between connector (J6)
and control panel.
(3)
Some installations require removal of the condenser side fabric cover. This generally applies only
when the air conditioner is positioned inside with condenser and fresh air openings ducted to the outside.
NOTE
If air conditioner is to be installed with condenser side (rear) exposed, the fabric cover should be
left in place if possible.
(a) Using screwdriver, remove fourteen screws, four packing with retainer, four lock washers, and
(b)
Carefully remove the fabric cover. Store the cover in a safe place for future use.
4-14