TM 9-4120-407-14
3-21. WIRING HARNESS (CONTROL PANEL) TESTING, REPAIR, AND REPLACEMENT. (Cont)
b. Removal.
NOTE
The wiring harness can be repaired while installed. Remove wiring
harness only if replacement is necessary.
(1) Tag and disconnect wire leads (1) Figure 3-30 from the control panel (2) components. See
Figure 3-30. Control PaneI Wiring Harness
(2) Remove two nuts (3), lock washers (4), screws (5), and wiring harness connector (6). Discard lock
washers.
c. Repair.
NOTE
Repairs to the wiring harness are limited to replacement of damaged
wire leads or connector only.
(1) Remove tiedown straps (7).
(2) Disconnect damaged wire lead(s) (1) from connector (6) and control panel (2) component(s). See
(3) Refer to Table 3-4 for wire size, length, and terminal information for new wire lead (1).
(4) Remove any remaining sleeving insulation (8).
3-88