TM 9-4120-407-14
3-26. EMI FILTERS AND SUPPRESSORS TESTING AND REPLACEMENT. (Cont)
(2) EMI Filter (FL2) Installation.
NOTE
Steps (a) through (c) only apply to installation of the bottom box,
fitting, and wiring harness. Do not perform these steps if only the
EMI filter has been removed.
(a) Install fitting (27) Figure 3-39 and fitting nut (26).
(b) Slip harness nut (24) over wiring harness (25).
(c) Insert wiring harness (25) leads into fitting (27) and secure using harness nut (24).
(d) Install plate (23), four screws (20), new lock washers (21), and flat washers (22).
(e) Install wire leads (17) using tags and wiring diagram Figure 3-5, four new lock washers (19),
and nuts (18). Remove tags.
(f) Install wire leads (5) using tags and wiring diagram Figure 3-5, four new lock washers (14),
and nuts (13). Remove tags.
(g) Feed connector (8) through box (4) and install six screws (10), new lock washers (11), and flat
washers (12).
( h ) Install gasket (9), connector (8), four screws (7), and new self locking nuts (6).
(i) Install box (4), four screws (1), new lock washers (2), and flat washers (3).
(j) Install control panel support.
1 Install shim (6) Figure 3-38, control panel support (5), four screws (3), and flat washers (4).
2 Install control panel assembly (2) and tighten screw (1).
(3) EMI Filter (FL1) Installation.
(a) Install EMI filter (1) Figure 3-37, doubler plate (5), six screws (2), new lock washers (3), and
flat washers (4).
(b) Install electrical components bracket. See paragraph 3-28.
(c) Connect wiring harness connectors to EMI filter (1) using tags and wiring diagram Figure 3-5.
Remove tags.
NOTE
FOLLOW-ON MAINTENANCE:
Install lower front panel. See para 3-14.
3-104
