TM 9-4120-408-14
5-9. CONDENDSER DATA PLATE AND SPRING CLIP REPLACEMENT
This task covers:
Remove
Install
INITIAL SETUP:
Materials/Parts (Continued)
Tools
Section III, Item 1
Item 7
8 (Spring clips)
Refer to TM 9-4120-408-24P for part numbers Of items
Section III, Item 16
to be replaced.
Equipment Conditions
Materials/Parts
General Safety Instructions
Do not work on equipment without following standard
shop safety precautions.
CAUTION
Dehydrator must be replaced every time the air conditioner lines are exposed to the
atmosphere. Failure to obey thin caution may result in equipment damage.
NOTE
This procedure applies to the data plate shown. The procedure for the spring clip and the
identification plate are similar.
a. Remove. Remove six rivets (Figure 5-4, 1)
and data plate (2). Discard rivet (1).
b. Install.
(1) Position data plate (2) on condenser assembly (3) and secure with six new rivets (1).
(2) Follow on maintenance:
(a)
(b)
Change 1 5-17