TM 9-4910-387-14-2
13 Check for continuity. If continuity does not exist on any of the
checks performed in steps 8 thru 11 above, disassemble male
connector plug (21) (p 6- 395) and check if wires are con-
nected to contacts.
a. Connect wires as necessary.
b. If wires are connected, replace the open wire (p 6-395).
14 If LUBE HEAT light does not light, proceed to step E.
E. FEMALE AND/OR MALE CONNECTOR PLUGS MAY BE DEFECTIVE.
1 Disassemble female and male connector plugs (1 and 2) (p 6-187
2 Check for burnt or corroded terminals (3).
terminals are burnt or corroded.
6-61