TM 9-4910-387-14-2
6-6. LH CONTROL EQUIPMENT ASSEMBLY-MAINTENANCE INSTRUCTIONS (cont)
INITIAL SETUP (cont)
References
MANIFOLD HEAT light does not light
TM 9-4910-387-24P
POWER ON light does not light
TACHOMETER indicator assembly does not func-
Troubleshooting References
tion, FORWARD-OFF-REVERSE switch is in FOR-
6-31
Auxiliary motor fails to start, AUXILIARY MOTOR
WARD position
switch is in the on position
TACHOMETER indicator assembly does not func-
6-132 Drive speed of tester will not decrease
tion, FORWARD-OFF-REVERSE switch is in RE-
6-126 Drive speed of tester will not increase
VERSE position
Main drive motor fails to start, FORWARD-OFF-
REVERSE switch is in FORWARD position
Equipment Conditions
Main drive motor fails to start, FORWARD-OFF-
Main power source to tester is turned off
REVERSE switch is in REVERSE position
4-42
LH panel assembly is removed
REMOVAL
NOTE
Before disconnecting and
removing wires, ensure that
wires are identified and
tagged for reassembly. The
1 FOURTEEN
SCREWS
(1)
AND
terminal strip on the RH side
NINETEEN ATTACHED WIRES ON
of the LH mounting board
THE RH TERMINALS OF TERMINAL
STRIP B (2). Remove.
assembly is referred to as
terminal strip B.
6-220
