Test stand (type II, part number 7336) (4910-316-5252) - right front view.
varidrive assembly. It identifies the high-speed
ber, contract and specification number, and the
manufacturer's name and address.
head and specifies the rpm (revolutions per
minute) range, and cautions the operator not
j. Reversing Switch Precautionary Instruc-
tion Plate. This plate is mounted above the high
h. Low-Speed Head RPM Range Plate. This
voltage compartment door, behind which the
drive reversing switch is located. It cautions
plate is mounted on the right hand drive head of
the varidrive assembly. It identifies the low
the operator not to operate the drive reversing
switch (fig. 12) while the varidrive assembly is
speed head and specifies the rpm range.
in motion.
i. Test Stand General Information Plate.
This plate is mounted on the right hand side of
Plate. This plate is mounted on the meter panel
the main control panel of the test stand. It
specifies the Federal stock number, manufac-
above the tachometer indicator meter (3, fig.
16) and cautions the
operator not to
exceed the
turer's type and model numbers, serial num-