TM 9-2330-356-14
(8) Remove two capscrews (13) and nuts (5) that
Installation.
b.
fasten rear firewall sections (14 and 12) to rear panel (6).
(1) If engine was removed from base frame,
(9) Remove capscrews (9 and 8) and nuts (10) that
fasten engine base to frame with four mounting screws
fasten panels (6 and 7) to base frame (11).
and nuts.
(24), and nuts (23) from bottom of fan shroud (22).
(2) Install rear firewall sections (14 and 12), and
fasten to base frame with screws (13) and nuts (5).
(11) Using a hoist, remove panels (6 and 7),
muffler stand (1), and fan shroud (22) from base frame as
(3) Position panels (6 and 7), muffler stand (1),
an assembly.
and fan shroud (22) as an assembly over engine. Position
support bracket (18) on front panel (7), and fasten to base
(12) Remove remaining capscrews (13) and nuts
frame (11) with six capscrews (9) and nuts (10). Install
(5), and remove rear firewall sections (14 and 12).
remaining capscrews (9 and 8) and nuts (10) to fasten
(13) The base frame can be used as a holding
panels to base frame. Do not install the four capscrews (9)
fixture for the engine. If engine is to be removed from base
and nuts (10) for the rear cross brace until the engine and
frame, remove four mounting screws and nuts.
5-25