TM 9-2330-211-14&P
4-22. BRAKESHOES-MAJOR ADJUSTMENT (Con't)
ACTION
LOCATION
ITEM
REMARKS
FOLLOW-ON MAINTENANCE:
TASK ENDS HERE
4-23. SLACK ADJUSTER
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
Hammer, ball-peen
Hydraulic jack and handle
Pliers, slip-Joint
Materials/Parts:
Punch, drive-pin
Socket, In., In. drive
Cotter pin
Wrench, open-end, 7/16 In.
Personnel Required: Two
ACTION
LOCATION
ITEM
REMARKS
NOTE
All slack adjusters are replaced the same way. Only one is
covered In this procedure.
REMOVAL
1.
Clevis pin (1)
Cotter pin (3)
Using pliers, pull out and discard.
2.
Clevis (2)
Clevis pin (1)
Using drive-pin punch and hammer, push out.
3.
Camshaft (8)
Bolt (5),
Using in. socket and handle, unscrew and take off.
lockwasher (4),
and keywasher (6)
4.
Slack adjuster (9)
Using hammer, hit and slide off end of camshaft (8).
4-60