Exhaust blower, front and rear view.
copper wire from the circuit breaker
to the heating element and remove
Caution: Be extremely careful
when removing this lead. Do not
alter the length or shape of the bare
Tag and remove the wire connations
from the plug-in terminals on the
heati ng element.
Remove the screws that secure the
Figure 34. Exhaust blower, schematic-wiring
heating element to the cabinet. Be
careful not to bend the louvers on
motor in the bracket. Slide the im-
the front of the cabinet during the
peller onto the motor shaft and tight-
en the fastener.
Position the replacement element and
(6) Replace the motor bracket in the cab-
replace and tighten the screws.
inet and connect the motor leads
Connect the wires to the plug-in
g. Removal and Replacement of Heating
Replace the bare wire connected
from the circuit breaker ((2)
(1) Remove the screws that secure the
motor bracket to the cabinet and re-
Position the motor bracket in the
move the motor bracket.
cabinet and replace and tighten the
(2) Loosen the bolt that secures the bare