TM 3-1040-262-13&P
Table 3-1. Operator's Preventive Maintenance Checks and Services.
NOTE
Within designated interval, these checks are to be performed in the order listed.
B-Before Operation
A-After operation
Interval
Procedures
For readiness reporting
Item
Check and have repaired or
equipment is not ready/
No.
B
A
Item to be inspected
adjusted as necessary
available if
1
OVERALL VISUAL
Inspect the disperser to make sure
that all parts are clean, properly
installed, and serviceable.
Insure that all hose connections
are tight. Check the three lock
ring equipped quick-disconnect
couplings. These are: quick-
disconnect male couplinq half
disconnect female coupling of the
discharge hose; the discharge hose
quick-disconnect female coupling
connection to the nipple (18,
assembly (17) to the manifold
coupler assembly (19). (See NOTE
at end of table 3-1.) Check the
remaining quick-disconnect coupling
connections. These connections are
as follows: manifold coupler assembly
(19) to quick-disconnect male
coupling half (fig. 1-3); valve
actuating coupler assembly (13,
fig. 1-4) to nipple assembly (14)
and quick-disconnect female coupling
half (8) to quick-disconnect
male coupling half (7). If
overall inspection reveals deficiencies
in the hose connections,
notify organizational maintenance
personnel. Inspect the agent con-
tainer assembly (fig. 1-3) to make
sure that it is not damaged. Make
certain that the drain cock (16,
wise). Visually inspect the
threaded and quick-disconnect
coupling connections on the high-
3-2
