TM 55-1930-208-10
3-22. OIL PRESSURE GAGE.
This task covers:
a.
Removal
b.
Inspection
c.
Installation
SET-UP:
Tools Required:
Tool Kit, General Mechanic's
Materials Required:
Washer, Lock P/N MS35338-42
Equipment Conditions:
Engine shut down (paragraph 2-11).
Vessel is moored (paragraph 2-7).
a. Removal. (Refer to figure 3-20).
(1) Disconnect oil line (1) from rear of gage (4).
(2) Remove two nuts (2) and two lockwashers (3), and remove gage (4) from front of panel (5).
(3) Remove screw (6), lockwasher (7), clamp (8), and tube (9).
(4) Remove elbow (10), bushing (11), and tee (12).
b. Inspection.
(1) Inspect gage for damage to the face.
(2) Inspect oil line for bends, kinks, or leaks.
c. Installation.
(1) Install tee (12), bushing (11), and elbow (10).
(2) Install tube (9), clamp (8), lockwasher (7), and screw (6).
(3) Install gage (4) in panel (5) and secure with two lockwashers (3) and two nuts (2).
(4) Connect oil line (1) to gage (4).
3-50
