TM 55-1930-208-10
3-23. ETHER STARTING AID.
This task covers:
a.
Removal
b.
Service
c.
Installation
SET-UP:
Tools Required:
Tool Kit, General Mechanic's
Equipment Conditions:
Engine shut down (paragraph 2-11).
a. Removal. (Refer to figure 3-21).
(1) Loosen wing nut (1) and unscrew ether bottle (2).
(2) Remove two nuts (3), two screws (4), and clamp (5).
(3) Remove tube (6) and atomizer (7).
(4) Remove two nuts (8), two screws (9), clamp (10), and control (11).
(5) Remove two screws (12), clamp (13), valve (14), and bracket (15).
b. Service. Service is limited to replacing the ether bottle.
c. Installation.
(1) Install valve (14), and clamp (13) on bracket (15). Secure clamp (13) with two screws (12).
(2) Install bracket (15) and valve on panel. Install control (11) and clamp (10) and secure on bracket (15) with
two screws (9) and two nuts (8).
(3) Install atomizer (7) and tube (6).
(4) Install clamp (5) on panel and secure with two screws (4) and two nuts (3).
(5) Screw ether bottle (2) into valve (14) and tighten wing nut (1).
3-52
