TM 9-1345-203-12
be restored. If the M15 mine has been
(19) To arm fuze, lie in prone position, raise
destroyed, packaging and all inside
safety pin to horizontal position, and grasp
components may be destroyed.
safety bank and safety stop with left hand
right hand index finger, pull safety pin out
while sliding it to the right (figs. 2-42 and
2-43). Carefully remove safety stop while
holding safety band in place. If any
cracks are noted in plastic collar, while
still in prone position, slowly and carefully
reassemble stop and safety pin on fuze so
that pressure ring is immobilized.
Remove extension rod carefully. Remove
fuze from mine, using extension rod if
necessary. Turn fuze in to ASP for
disposal and replace it with a new fuze. If
no cracks are noted, carefully remove the
safety band (fig. 2-44). THE FUZE IS
NOW ARMED!
(20) After emplacement of M15 mine with
M624 fuze, all unused M603 fuzes, end
closures, safety pins, bands, stops,
arming plugs, and arming wrenches must
be retained and stored in their respective
packaging material and then turned into
supply. They will remain in storage until
the M15 mine has been destroyed or is to
