TM 9-1345-203-12
rotate knob to that position and reinstall
c. Laying and Arming.
safety clip.
Detonator holder loading
(1) Remove mine and fuze assembly (fig. 2-
assembly must not be in fuze while setting
47) from shipping container.
knob is being adjusted.
(2) Inspect mine and fuze for cracks, breaks,
(6) Turn fuze bottom-side up and remove
or other condition that may render mine
white plastic shipping plug from detonator
unserviceable.
If damage is found,
well, using wrench M22 and turning in
replace with new mine.
counterclockwise direction.
(3) Using wrench M22, remove fuze from
(7) Examine for foreign material and, if
fuze well by turning fuze counterclockwise
present, remove foreign material from
until free. Lift up from fuze well (fig. 2-
opening.
47).
(8) Visually check position of firing pin. If
(4) Check fuze well for foreign matter. If
armed (firing pin centered) (fig. 2-48),
present, remove foreign matter.
reject fuze. If not armed (firing pin point
(5) Assure that setting knob is in S (Safe)
positioned at edge of hole), continue to
position and safety clip is in place. If
next operation.
setting knob is not in S position, remove
safety clip and
