TM 9-1345-203-12
(21) Reconnect firing device to discriminator
WARNING
and assure that indicator light is not lit.
IN POSITIONING PEEPSIGHT, KEEP
(22) If light is lit, check and straighten any
HANDS AND ARMS CLEAR OF
kinks or twists in discriminator that could
LAUNCHER ENDS.
cause enough pressure to complete
electrical circuitry.
(12) Break twig or stick to length of
(23) If light continues to glow, do not use
approximately 1 meter (39 inches).
system.
(13) Return to road center and target impact
(24) If light goes out, proceed with next step.
point, position stick upright at this point
(center of discriminator) and support
NOTE
(rocks, sticks, etc.).
All traces of implanted mine system
(14) Return to launcher and sight through
must be carefully camouflaged.
peepsight of sighting assembly to top of
stick. Steady sighting assembly with light
(25) Recheck
camouflaged
discriminator,
touch while sighting. Adjust position of
disguising any exposed section.
launcher only (proper elevation is
achieved by adding or removing earth at
aft end), treating both devices as a single
NOTE
unit; position both by manipulating rear of
Avoid applying pressure to, or
launcher.
changing
position
of,
discriminator.
All
other
WARNING
components of system must be
IN ALL HANDLING AND SIGHTING
disguised.
OPERATIONS, REMAIN CLEAR OF
Make
final
check
through
REAR AND FRONT OF LAUNCHER.
sighting device to assure that
SIGHT WITH BODY STRETCHED AT
proper aim has been maintained.
RIGHT ANGLES TO LAUNCHER.
If aim has not been maintained,
adjustments may be made by
(15) Temporarily remove sighting assembly.
carefully manipulating rear of
(16) Fill dispenser pouch with loose earth to
launcher. Then remove sight and
about 6 inches from top to allow for tying.
camouflage light.
Remove
Fill accessories pouch with loose earth so
sighting stick.
as to allow for closing and snapping of
cover.
(26) Remove dust cap from rocket cable
(17) Close both pouches.
assembly connector; lift up safety cover
(18) Lay dispenser pouch across launcher
and remove dust cap on firing device
about 1 inch to rear of forward taped
connector labeled ROCKET; and join
plastic cover.
connectors (fig. 2-63).
(19) About 2 inches aft of dispenser pouch,
place accessories pouch over launcher.
WARNING
Rear of launcher must remain clear.
DO NOT ATTEMPT TESTING AFTER
(20) Reposition sighting assembly, straddling
ROCKET CABLE ASSEMBLY IS
dispenser pouch. Assure legs of sighting
CONNECTED TO FIRING DEVICE.
assembly are positioned on launcher and
are not caught in or resting on pouch,
(27) Throw toggle switch to ARM position.
plastic cover, dirt or tape.
2-71
