TM 9-1345-203-12
2. Retain firing mechanism of
10. After removing fuze, screw
arming plug back into place,
firing device. Base coupling
hand tight, with pointer on
with fired primer should be
setting knob pointing to SAFE.
replaced.
Firing mechanism
11. Remove
tripwires
and
may be recocked by placing
end of stick, pencil, or nail
replace tape over secondary
against firing pin and pushing
fuze well.
back until it is held in place by
12. If required, remove sand from
release pin.
mine.
3. Install safety pin.
13. Restore mine and fuze to
original position and packing.
4. Restore mine, new fuze, new
14. Mine may be laid and removed
practice activator, and firing
any number of times, provided
device to original condition and
neither fuzes nor mines show
packing.
evidence
of
damage
or
(2) Mine, Antitank, Practice: Heavy, M20 (fig.
(e) To Reuse Functioned Mine and
disarming, removal (neutralizing), recovery, and
Fuze.
refuzing procedures for the practice mine M20 and
1. If mine and fuzes have
practice fuze M604, are similar to those found in
paragraphs b(l) (a) through (e).
functioned and mine casing is
undamaged, replace main fuze
and practice activator with new
ones.
2-76
