TM 9-2320-366-10-2
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DOES NOT
ILLUMINATE
NOTE
Perform Electrical System Troubleshooting (e1. Engine Does Not Crank), prior to
beginning this task.
Check circuit breaker (CB35 and CB79) in PDP to see if they are tripped.
(a)
Remove PDP cover (para 3-17a).
(b)
Position master power switch to off (para 2-27f).
(c)
If circuit breaker(s) is tripped, push in to reset.
(d)
Position master power switch to on (para 2-27a or b).
(e)
Check circuit breakers in PDP to see if they tripped again. If circuit breakers tripped again,
notify Unit Maintenance.
(f)
Position master power switch to off (para 2-27f).
(g)
Install PDP cover (para 3-17b).
(h)
If WTEC II TEPSS still does not illuminate, notify Unit Maintenance.
TRANSMISSION UNUSUALLY NOISY WHEN OPERATING.
Step 1. Check transmission oil level (para 2-18, item 36).
(a)
If transmission oil level is low, add transmission oil (Appendix F).
(b)
If transmission oil level is high, notify Unit Maintenance.
Step 2. Check transmission oil for contamination.
(a)
If transmission oil is contaminated, notify Unit Maintenance.
(b)
If transmission is still unusually noisy when operating, notify Unit Maintenance.
WTEC III TRANSMISSION PUSHBUTTON SHIFT SELECTOR (TPSS) DISPLAYS "--"
AND/OR DOES NOT SHIFT GEARS.
Notify Unit Maintenance.
WTEC III TRANSMISSION PUSHBUTTON SHIFT SELECTOR (TPSS) DOES NOT
ILLUMINATE
NOTE
Perform Electrical System Troubleshooting (e1. Engine Does Not Crank), prior to
beginning this task.
Check circuit breaker (CB43 and CB79) in PDP to see if they are tripped.
(a)
Remove PDP cover (para 3-17a).
Change 1
