TM 9-2330-205-14&P
HYDRAULIC MASTER CYLINDER - CONTINUED
NOTE
TASK ENDS HERE
HYDRAULIC WHEEL CYLINDER
This task covers:
INITIAL SETUP
Materials/Parts
Tools
Container
Handle, reversible, 3/8-inch square
Washer, copper
drive
Socket, 1/2- by 3/8-inch square
Equipment Condition
drive
Socket, 11/16- by 3/8-inch square
drive
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
All parts of the service brake assembly will be coated with asbestos dust from the brake
linings. A filter mask should be worn whenever working on any assembly components.
Breathing asbestos dust may cause serious damage to health.
NOTE
Place a container under backing plate to catch brake fluid.
1.
Connector (1)
Bolt (2) and washers
Using 11/16-inch socket wrench, remove.
Discard washers (3 and 4).
(3 and 4)
TWO bolts (6)
Backing plate (5)
2.
Using 1/2-inch socket wrench, remove.
Wheel cylinder (7)
3.
Remove and separate.
and spark shield (8)