TM 9-2330-205-14&P
HYDRAULIC BRAKE LINE REPLACEMENT
This task covers:
d. Axle tee to left service brake
a. Master cylinder to union (page 4-50)
b. Union to axle flex hose (page 4-51)
e. Axle tee to right service brake
c. Axle flex hose (page 4-52)
INITIAL SETUP
.
Materials/Parts
Tools
New lines (as required)
Screwdriver, cross-tip
Wrench, open-end, 7/16-inch
Wrench, open-end, 1/2-inch
Wrench, open-end, 5/8-inch
Wrench, open-end, 15/16-inch
ACTION
ITEM
REMARKS
LOCATION
MASTER CYLINDER TO UNION
Fitting (3)
Using 5/8- and 7/16-inch open-end
Line (1) to master
1.
wrenches, remove.
cylinder (2)
Two screws (6), two
Using 7/16-inch open-end wrench and
2.
Clamps (4) to
Iockwashers (7),
cross-tip screwdriver, remove.
frame (5)
and two nuts (8)
Using 7/16- and 1/2-inch open-end
Fitting (10)
Union (9) to
3.
wrenches, remove.
line(1)
Remove.
Frame (5)
Grommet (11)
4.
Line (1)
Remove.
5.
Two clamps (4)
Remove.
Line (1)
6.
Discard line (1).
Install.
Two clamps (4)
New line
7.
Line (1)
Place in position.
Frame (5)
8.
Grommet (11)
Install.
9.
Fitting (10)
Using 7/16- and 1/2-inch open-end
10.
Union (9) to
wrenches, install.
line (1)
