TM 9-2330-227-14&P
SERVICE BRAKES, TWO-WHEEL CYLINDER - CONTINUED
ADJUSTMENT - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE:
TASK ENDS HERE
SERVICE BRAKES, ONE-WHEEL CYLINDER OPTION
This task covers:
INITIAL SETUP
Personnel Required
Tools
One
Gage, thickness, 0.005-inch
Gage, thickness, 0.010-inch
Equipment Condition
Socket, 1/2-inch drive, 5/8-inch
Wrench, open-end, 1/2-inch
Wrench, open-end, 11/16-inch
Wrench, open-end, 11/16-inch
Wrench, open-end, 11/8-inch
ACTION
ITEM
REMARKS
LOCATION
ADJUSTMENT
NOTE
Both service brakes are adjusted the same way. This task is for one; repeat for others.
Nut (3), lockwasher
1. Brakedrum (1) and
(4), and inspection
handle with 1/2-inch drive, unscrew
bolt (2)
hole cover (5)
and take off.
Locknut (7)
Using 11/16-inch open-end wrench,
2. Backing plate (6)
loosen.
Inspection hole (8)
a. Rotate brakedrum (1) until inspection
3. Brakedrum (1)
hole (8) is 11/2-inches from end of
one brake lining (9) nearest
anchor pin (10).
Change 1
4-82