BRAKESHOE ASSEMBLIES, ONE-WHEEL CYLINDER OPTION
This task covers:
c. Inspection/Replacement (page 4-90)
a. Removal (page 4-88)
d. Installation (page 4-90)
b. Cleaning (page 4-89)
INITIAL SETUP
Materials/Parts
Tools
Solvent, drycleaning, PD-680
Brush, paint, 17/16-inch
(item 18, appendix E)
Compressor unit, reciprocating air
Gage, depth
Personnel Required
Gun, blow, air
Hammer, hand, ball-peen, 24b
One
Handle, ratchet, 1/2-inch drive
Mask, protective
Equipment Condition
Pliers, repair, brake
Pliers, slip-joint
Air reservoir drained (page 2-13).
Pliers, straight-jaw
Hub and drum removed (page 4-143).
Screwdriver, flat-tip, 3/16-inch
Socket, deep well, 1/2-inch drive,
7/16-inch
ACTION
REMARKS
ITEM
LOCATION
Brake linings contain asbestos fibers. Protective mask must be worn while performing
maintenance on brake linings. Failure to do so could result in injury or death to
personnel.
NOTE
Both sets of brakeshoes are removed, cleaned, inspected/replaced, and installed the
same way. This task is for one set; repeat for the other.
REMOVAL
Two C-washers (2)
Using 3/16-inch flat-tip screwdriver and
1. Two anchor
and strap (3)
ball-peen hammer, take off washers (2)
pins (1)
and strap (3).
Brake retract
Using brake repair pliers, take off.
2. Two retract
spring (5)
spring pins (4)
4-88
