TM 9-2330-227-14&P
LANDING GEAR AND BRACKET - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
DISASSEMBLY
NOTE
The following disassembly and assembly procedures apply to one leg. If necessary,
repeat on other leg.
Two screws (2)
Using two 9/16-inch open-end wrenches,
9. Coupling (1)
and nuts (3)
unscrew and take out.
Shaft (5), stowage
10. Bracket (4)
Pull out.
bracket (6), and
Bracket and coupling will fall
coupling (1)
loose.
Three screws (8)
Using 3/4-inch socket and ratchet handle
11. Bracket (4)
and Iockwashers (9)
with 1/2-inch drive, unscrew and take out.
and gear box (7)
Bracket (4)
Take off.
12. Gear box (7)
Four screw
13. Cover (10)
Using 3/8-inch flat-tip screwdriver,
and washer
unscrew and take off.
assemblies (11)
Cover (10) and
Lift off.
gasket (12)
15.
Spring (13)
Using long round-nose pliers, pull
spring from seat in gearbox (7).
16. Crankshaft (14)
Pin (16)
Using 3/16-inch drive-pin punch and
and gear (15)
ball-peen hammer, drive out.
17. Gear (15) and
Crankshaft (14)
Pull out.
gearbox (7)
Ball will drop out of seat as
crankshaft is removed.
Gear (15), pin (16),
Lift out.
and ball (17)
Two lubrication
19. Gear box (7) and
Using 7/16-inch open-end wrench,
fittings (19)
upper leg (18)
unscrew and take out.
Two pins (21)
20. Gear shaft (20)
Using 5/32-inch drive-pin punch and
ball-peen hammer, drive out.
5-54
