TM 9-2330-227-14&P
LANDING GEAR AND BRACKET - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
ASSEMBLY - CONTINUED
Put in.
Bevel gear (17),
washer (18), and
rigid gear set (19)
Start into bore.
Gear shaft (20)
58.
a.
Aline with bores of bevel gear,
Gear shaft (20)
59. Bevel gear (17),
washer, and rigid gear set.
washer (18), and
b.
rigid gear set (19)
Push through rigid gear set (19).
Key (21)
a.
Using 1/2-inch drift and ball-peen
60. Gear shaft (20)
hammer, tap in.
b.
Push through bevel gear (17) and
washer (18).
Using 1/2-inch drift and ball-peen
Pins (22)
61.
hammer, tap in.
Place in position.
Gear (23)
Push through.
Crankshaft (24)
and gear (23)
Pin (25)
Using 3/16-inch drive-pin punch and bail-
64. Crankshaft (24)
peen hammer, drive in.
and gear (23)
5-59
