TM 9-2330-227-14&P
LANDING GEAR AND BRACKET - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
DISASSEMBLY - CONTINUED
WARNING
Drycleaning solvent PD-680 is both toxic and flammable. Avoid prolonged breathing of
vapors, and avoid skin contact. Use only in well-ventilated area, and keep away from
open flame or excessive heat. Injury to personnel could occur.
Bevel gear (2)
a. Using rag dampened with cleaning
Gear box (1)
solvent, wipe away grease.
b. Jam gear with wood block so it will
not turn.
Lower leg
Locknut (4)
Using 17/16-inch socket and ratchet
screw (3)
handle with 3/4-inch drive, unscrew and
take off.
Bevel gear (2)
a. Take out wood block.
and key (5)
b. Using bearing and gear puller, pull off.
Bearing cone (6)
Gear box (1)
Using 1/16-inch flat-tip screwdriver,
lift out.
Bearing cup (7)
Using bearing puller, pull out.
Remove only if worn or damaged.
Gib plug (8)
Using long round-nose pliers, pull out.
Gib spring (9)
Gib plug (8)
Upper leg (10)
Using 3/8-inch flat-tip screwdriver,
unscrew and take out.
Lower leg (11)
Pull out as an assembly.
and screw (3)
As assembly is pulled out, gib (12)
will be forced out of upper leg (10).
Watch so that gib (12) is not lost.
Lower leg
Bearing (13)
Pull off.
screw (3)
Lower leg screw (3)
Nut (14)
Unscrew, and take out.
Two pins (15)
Push into free nut in lower leg.
Nut (14)
Lower leg (11)
a. Using puller, pull out.
b. Take two pins (15) out of nut (14).