TM 9-2330-231-14&P
Section XII. SPRINGS AND SHOCK ABSORBER
Page
Page
Radius Rod Adjustment ...................................... 4-123
Shock Absorber ................................................4-119
Radius Rod........................................................ 4-121
Spring Assembly.. .............................................4-115
SPRING ASSEMBLY
This Task Covers:
a. Spring removal (page 4-115)
c. Roller installation (page 4-117)
b. Roller removal (page 4-117)
d. Spring installation (page 4-118)
INITIAL SETUP
Tools
Tools - Continued
Handle, reversible, 1/2-inch square
Socket, 1 1/8- by 1/2-inch square drive
drive
Wrench, Allen, 3/16-inch
Jack, hydraulic
Wrench, open-end, 15/16-inch
Jack stands (two each)
Mallet, plastic
Personnel Required
Socket, 15/16- by 1/2-inch square
drive
Two
ACTION
LOCATION
ITEM
REMARKS
SPRING REMOVAL
1. Axle (1)
Jack (2)
Raise axle (1) and position jack stands
(3) at rear to support chassis (4).
2.
Axle (1)
Lower axle (1) so tires are on ground.
Jack stands (3) will hold weight off
springs.
TA223927
4-115
