TM 9-2330-247-14&P
4-26. CHASSIS WIRING HARNESS (Con't)
ACTION
ITEM
LOCATION
REMARKS
Five grommets (6)
6.
Using long round-nose pliers, pull out.
Two clips (21)
7.
Eight screws (11 ),
Using no. 2 cross-tip screwdriver and
in. open-
end wrench, unscrew and take off.
and two rear
nuts (9), and
Three prong and four prong clips are
Iockwashers (10)
comer clips (12)
removed the same way.
Two clips (21)
Take off.
8.
Frame (7)
and two rear
corner clips (12)
MALE CONNECTOR REPAIR
NOTE
If chassis wiring harness was removed from frame, skip step
9.
Pull out and take apart.
Two clips (12
9.
Connectors (14 and
15) or (18 and 19)
or 21)
Wire lead (22)
Take off.
Slide up until clear of contact (25) and retaining
10.
washer (24).
Take off.
Retaining
11.
washer (24)
Slide off and get rid of.
12.
Shell (23)
NOTE
If replacing shell only, skip steps 13, 14a, and 14c.
Using cutting pliers, cut off.
13.
Contact (25)
Be sure enough wire lead (22) remains to
make connection after repair. Discard
contact.
4-27
