TM 9-2330-247-14&P
This Task Covers:
a. Removal
c.
Installation
b. Lamp, Lens, and Door Assembly Replacement
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
Handle, ratchet, 3/8 in. drive
Intervehicular cable disconnected from towing ve-
Screwdriver, flat-tip, 1/4 in.
hicle (para 2-12).
Socket, 3/8 in. drive, 1/2 in.
NOTE
If wire connectors are to be repaired or replaced, refer to chassis wiring harness task
Removal is not necessary for lamp, lens, or door assembly replacement. If replacing
lamp, lens, or door assembly only, go to step 4. If circuit marker bands are missing or
illegible, replace (para 4-26).
REMOVAL
1.
Blackout stoplight
Connector (2)
Pull out.
assembly (1)
2.
Bracket (5) and
Screw (6) and
Using 1/2 in. socket and ratchet handle with 3/8 in.
blackout stoplight
Iockwasher (7)
drive, unscrew and take out.
assembly (1)
3.
Bracket (5)
Blackout stoplight
Lift up and take off.
assembly (1)
