TM 9-2330-251-14&P
Section X. FRAME AND TOWING ATTACHMENTS MAINTENANCE
Page
Number
Paragraph Title
Actuator With Drawbar Coupler Maintenance (M416A1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Channel Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Drawbar Coupler Maintenance (M416) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Landing Leg Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-39. CHANNEL REPLACEMENT.
This Task Covers:
Installation
b.
a.
Removal
Initial Setup:
Materials/Parts:
Equipment Conditions:
Actuator w i t h drawbar coupler removed
Two locknuts
(M416A1 ) (para 4-40).
Two Iockwashers
(M416)
Drawbar
coupler
disassembled
Personnel Required: Two
Intervehicular cable removed (para 4-20).
Tube assembly removed (master cylinder to
coupler) (M416A1) (para 4-34).
Tools/Test Equipment:
General mechanic's tool kit
Common No. 1 shop set
Torque wrench, 0-175 Ib.-ft. (0-237 N.m)
1.
Remove 2 nuts (7), lockwashers (6) ,and screws (3) securing channel (8) to chassis bracket (4), Discard
NOTE
On right side only, handbrake lever and mounting bracket are removed when U-bolt
(9) is removed.
2.
Remove 2 locknuts (2) from U-bolt (9) securing channel (8) to front crossmember (1). Remove U-bolt
and channel from chassis (5). Discard locknuts.
1.
Position channel (8) for installation.
4-66
