TM 9-2330-294-14
(h) It should be noted that if the service
(g ) Disconnect connector at inoperative
clearance lamp circuits are being tested and an open
component. Connect one meter lead to connector on
main harness (CPR 102836 for semitrailer no. 1
circuit condition exists, then an additional open
through 200; 11675789 for semitrailer no. 201 and
circuit test must also be made on each CPR 102845
harness for semitrailer no. 1 through 200 and
on). Connect the other lead to ground. Full deflection
on the ohmmeter should occur (zero ohms). If full
11675775 harness for semitrailer no. 1 through 200
deflection occurs, then the component assembly is
and 11675775 harness for semitrailer no. 201 and on.
connected between each clearance lamp assembly
defective. If full deflection does not occur, and the
open circuit is not visible, a new wire is required
and the main harness (CPR 102836 for semitrailer
between the connector on the main harness and the
no. 1 through 200; 11675789 for semitrailer no. 201
pin on the trailer receptacle J1; notify support
and on. )
personnel.
