TM 9-2330-294-14
a. Ramp Reflectors and Brackets. Remove two
a. Removal.
machine screws securing reflector to bracket.
(1) Remove holddown strap from snatch block.
(2) Remove safety pin from pin assembly, and
securing bracket to ramp. Replace damaged parts.
remove pin from frame bracket.
Coat holes and bracket interface near holes with
(3) Remove snatch block.
sealing compound (MIL43- 11031). Install bracket
b. Installation. Install snatch block in the reverse
and reflector in reverse order of removal.
order of removal.
c. Lubricate. Lubricate sheave bearings through
screws and lock washers and remove reflector. In-
fitting in sheave center pin semi-annually or when
stall new reflector in reverse order of removal.
Organizational maintenance of the roller assemblies
Install new reflector in reverse order of removal.
Notify direct support personnel if repair or
replacement is required.