TM 9-2330-294-14
plates and remove corrosion with stiff fiber brush.
A p p l y lacquer to preserve plates. Replace
unreadable data plates.
aintain data plates in readable condition. Clean
Section XIII. DRAIN HOLES INSTALLATION, SNATCH BLOCK BRACKET
c. Make a punch mark at the center of the snatch block
4-72. Drain Holes
Installation, Snatch Block Bracket.
holding bracket.
a. Remove the snatch block hold down strap assembly.
d. Measure 2 3/8 inches from center punch mark along
b. Lift the snatch block and rotate it around the hinge
the longitudinal axis toward the front of the trailer and
pin to the other side to gain access to the cross member for
make another punch mark inside the round holding bracket.
e. Drill two 1/2 inch diameter holes at the punch marks.
Change 1