TM 9-2330-294-14
pavement. Measure the distance between the
semitrailer, should be within 1/8 inch of each other.
kingpin centerline mark and the two axle end marks.
Distances (D) should be within 3/16 inch of each
These distances (E) should be within 1 /8 inch of each
other. Use a plumb bob to mark the centerline of the
other.
kingpin and the centers of the first axle ends on the
b. Rear Suspension Alinement Adjustment. If
beam are oversize for this adjustment. If adjustment
excessive tire wear occurs, when it is apparent that
is attempted, replace adapter pad and dowel pin.
the condition is not caused by tire operation or
Refer to a above for alinement dimensions. Refer to
inadequate maintenance, it may be desirable to
break the weld securing the axle adapter pad (fig. 5-
8) to the equalizer beam and adjust axle alinement
Section VI. REMOVAL AND INSTALLATION OF MAJOR
COMPONENTS AND ASSEMBLIES
store basic issue items for subsequent installation.
5-10. General
For a list of all basic issue items on the semitrailer
This section contains information for the guidance of
refer to appendix B.
direct support and general support maintenance
personnel responsible for removal and installation of
major components and assemblies. The instructions
provide a systematic procedure for disassembling
(1) Removal. Disconnect main wiring harness
and assembling the semitrailer in logical order.
from intervehicular cable receptacle cover and from
Before disassembling the semitrailer, remove the
circuit breakers. Disconnect side utility outlets from
spare wheel and all basic issue times (BII). Box and
