TM 9-2330-294-14
CAUTION
(2) Remove six cap screws, lock washers and
n u t s t h a t s e c u r e b r a c k e t s t o f r a m e . Remove
The wear pads and shims used in semitrailer
brackets.
No. 1 through 200 and semitrailer No. 201
b . I n s t a l l a t i o n . Install in the reverse order of
and on are not interchangeable. Take card to
removal. Torque frame bracket nuts to 130- 170 lb
replace damaged shims and pads with
ft. Torque bolts securing torque rod to frame bracket
correct parts.
t o 280-360 lb ft.
b . I n s t a l l a t i o n . Install in the reverse order of
removal. Torque nuts securing pads to 75 - 90 lb in.
on semitrailer No. 1 through 200 and/or torque cap
Remove and install loading ramps in accordance
screws securing pads to 42 - 57 lb ft on semitrailer
with procedures in paragraph 4-63.
No. 201 and on. Torque nuts on axle stops studs to
5-19. Landing Gear
6 5 - 9 0 lb ft. Using Torque wrench (GG - W-686)
Remove and install landing gear in accordance with
torque slotted nut securing sleeve assembly on
procedures in paragraph 4-66.
spindle to 850 - 1,050 lb ft on semitrailer No. 1
through 200 and/or torque slotted nut securing
bearing and block on spindle to 300-450 lb ft on
Remove and install axle lift bracket in accordance
semitrailer No. 201 and on.
with procedures in paragraph 4-62.
NOTE
5-21. Stowage Provisions Hardware
Shim as required to maintain 6 1/8 + 1/8
Remove and install stowage provisions hardward in
inch clearance between shims on semitrailer
accordance with procedures in paragraph 4-67.
no. 1 through 200 and/or shim as required to
maintain 5 5/8 + 1/8 inch clearance between
5-22. Snatch Block
shims on semitrailer No. 201 and on.
Remove and install snatch block in accordance with
procedures in paragraph 4-63.
a. R e m o v a l . R e m o v e t o r q u e r o d i n a c c o r d a n c e
with procedures in paragraph 5-13b (2) and (3).
b. Inspection and Repair. Inspect torque rod
a. Removal.
r u b b e r bushing for damage or deterioration. See
(1) Remove lock wire, two cap screws and
retainer securing roller assembly shaft in mounting
c. Installation. Install torque rod in accordance
bracket.
with procedures in paragraph 5-13f (6) and (7).
(2) Remove shaft, roller assembly, two flat
washers and two seals.
(3) Remove retaining ring on each end of roller.
Remove spacer and two roller bearings from roller.
a. Removal.
(1) Disconnect torque rods by removing nut,
two flat washers, bolt and two adapters that secure
t o r q u e rods to frame brackets.
